cavity wall

英 [ˌkævəti ˈwɔːl]

美 [ˌkævəti ˈwɔːl]

n.  (有保暖作用的)空心墙，夹壁墙

医学

牛津词典

noun

• （有保暖作用的）空心墙，夹壁墙
  a wall consisting of two walls with a space between them, designed to prevent heat from escaping
  1. cavity wall insulation
     空心墙隔热

柯林斯词典

• N-COUNT (隔音或防寒的)空心墙，夹层墙
  Acavity wallis a wall that consists of two separate walls with a space between them. Cavity walls help to keep out noise and cold.
  1. ...cavity wall insulation.
     空心墙隔音材料

英英释义

noun

• a wall formed of two thicknesses of masonry with a space between them

双语例句

• The Strength of Sand Mold for Vacuum Evaporation Pattern Casting ( VEPC) and the Moving of Cavity Wall
  负压实型铸造砂型强度及型壁移动的影响因素
• However, the construction of cavity wall masonry is not included in the current relevant standard, so research in this area are relatively small.
  但是，建设空斗墙砌体结构的相关标准却未被列入我国现行的规范中，因此对这方面的研究也相对较少。
• Cavity wall masonry structure is a kind of special structure, because of its simple construction, low cost, so long in many of our relatively low level of economic development are widely used in many areas.
  空斗墙砌体结构作为一种比较特殊的结构形式，由于其施工简便、造价低廉，因而长久以来在我国许多经济发展水平相对较低的地区得到广泛的采用。
• Because of the various reasons of the construction and use, the row-lock cavity wall usually has the low-strength mortar especially in the vast rural areas.
  由于建造和使用时的种种原因，空斗墙结构房屋往往出现砌筑砂浆强度很低的情况，尤其是在广大农村地区。
• Depending on the test results, the paper proposed a shear strength empirical formula which is suitable for high-performance ferrocement reinforcement rowlock cavity wall. This empirical formula is reference use to reinforcement design in the actual project.
  同时根据试验结果，提出了适合高性能复合砂浆钢筋网条带加固空斗墙砌体结构抗剪承载力的建议经验公式，可供加固设计人员在实际工程中参考使用。
• After entering the chamber, because of edge effects by the cavity wall, the flow rate of blank uneven, showing a distinct layered flow.
  在进入腔体以后，因边部受到腔体壁的影响，坯料的流动速率不均匀，可见明显的分层流动。
• Restoring force of small concrete hollow block cavity wall
  混凝土小型空心砌块空腔墙体的恢复力试验研究
• Conclusion Bonding resin could distinctly reduce microleakage and assure good adaptation between the cavity wall and amalgam.
  结论应用树脂粘结剂可增加充填体与洞壁密合度，明显减少银汞合金充填微渗漏。
• A ( test): after being eroded through acid, the cavity wall was spread with EM dental adhesive, then filled with silver amalgam.
  A组：经酸蚀后在洞壁周围涂以薄层EM粘结剂，吹匀随即以银汞合金充填。
• Discussion on the calculation formulas of injection mold cavity wall thickness
  注塑模型腔壁厚计算公式讨论